Advanced search

Forums : Technical Support : 1 (0x00000001) Unknown error code
Message board moderation

To post messages, you must log in.

AuthorMessage
Tim Kelley

Send message
Joined: 1 Jul 18
Posts: 24
Credit: 1,646,084
RAC: 7,548
Message 22331 - Posted: 8 Jan 2020, 18:48:20 UTC

I've gotten "1 (0x00000001) Unknown error code" from three VM tasks over the past week. I'm running VBox 5.2.28 (later versions seem to have communication problems) and BOINC 7.14.2 on a Win10 desktop, two CPUs in one task, 4-core processor, 16GB RAM.

This may be tough to debug, but any suggestions? Most of the tasks are completing successfully.
ID: 22331 · Report as offensive     Reply Quote
Jonathan

Send message
Joined: 27 Sep 17
Posts: 161
Credit: 7,580,022
RAC: 683
Message 22332 - Posted: 9 Jan 2020, 8:25:27 UTC - in response to Message 22331.  

I glanced at your computer results. Completely normal error. Sometimes the parameters are out of range. Look in your log for something like the below. My error rate has been under one percent for the project.

2020-01-06 14:03:10 (21528): Guest Log:  Optical depth is strange. You have:   9.5968647300400008E-003

2020-01-06 14:03:10 (21528): Guest Log: Note: The following floating-point exceptions are signalling: IEEE_UNDERFLOW_FLAG

2020-01-06 14:03:10 (21528): Guest Log: ERROR STOP Stopped due to parameter error
ID: 22332 · Report as offensive     Reply Quote

Forums : Technical Support : 1 (0x00000001) Unknown error code